Intermec EasyCoder PD4 Service Manual page 35

Switching or Replacing the Edge Guide
Intermec EasyCoder PD4—Service Manual
To remove the edge guide, follow these steps:
1 Unhook the coil spring from the hook at the bottom of the plastic edge
guide underneath the post.
2 Remove the coil spring and the washer, then pull up the edge guide and
save it away for possible later use.
Post
To install the edge guide, follow these steps:
1 Insert the edge guide into the slot in the post.
2 First fi t the washer and then the coil spring from underneath the post to
the protruding part of the edge guide and engage the coil spring to the
hook.
Note: The high edge guide is hinged to allow media load. Before remov-
ing an empty core or loading a roll of media, the guide must be fl ipped
down to a horizontal attitude. Likewise, after loading the media it must
be fl ipped back so it points straight up. Like the low edge guide, it can be
adjusted along the post to fi t different media widths.
Post
Be careful to fl ip the high edge guide straight up before closing the side
door, or the guide could be damaged.
Chapter 5—Media Supply
Edge guide
Hook
Washer
Coil spring
Edge guide
Hook
Washer
Coil spring
25