Defender SN502-4CH Instruction Manual page 69

ONLINE SOFTWARE
To change the status of motion detection for each camera:
1. Select the status drop down list under the camera you would like to turn the motion detection on/off.
2. Select on or off from the drop down list to turn the motion detection on or off for that camera.
3. Select the sensitivity drop down list to adjust the motion detection sensitivity. elect 1 to 5 from the drop down list to
adjust the sensitivity. 1 is the lowest sensitivity and 4 is the highest sensitivity.
4. Repeat for all desired cameras.
5. Select "apply" to save the changes.
To adjust the MD area
1. Select the MD Area button and a separate screen will appear with a red mask on the picture and a grid.
2. The screen is fully red; this is because the DVR is automatically set to detect motion throughout the whole screen.
3. To adjust the MD area for the desired cameras, highlight the squares where you do NOT want motion detected and
click the mouse. When the area is no longer shaded in red, the area will no longer detect motion.
4. Once motion detection areas have been determined, exit the screen by clicking confirm and select "apply", to save
settings.
Motion Settings
SN502-4CH
66