Connecting To Power; Connecting To Your Network - SignaMax 065-7310F Series User Manual

Connecting to Power

Connect the supplied AC power cord to the receptacle on the
back of the switch, and then plug the cord into a standard AC
outlet with a voltage range from 100 to 240 VAC.
Turn the Ethernet switch on by flipping the ON/OFF switch on
the rear of the unit to the I (ON) position. The O position is
OFF.
Figure 3: Rear view of the switch

Connecting to Your Network

Prepare a pair of fiber optic cables with SC or ST type
connectors at both ends.
If you are making a connection to a server or workstation, be
sure that it has a properly installed 100BaseFX network
interface card. Connect the Rx/Tx jacks on the target device
to the Tx/Rx jacks on the switch.
User Manual
Signamax ™ ™ ™ ™ 065-7310F 8-Port 100BaseFX Fiber Switches
11