Installation - Windster RA35U30SS User Manual

8

INSTALLATION

1. UNDER CABINET INSTALLATION
a. Make sure all preparation steps are completed.
b. Feed the wires coming out of the hood through the bottom of the cabinet.
c. Lift the unit up flush against the wall and the bottom of the cabinet.
d. Using the screws and washers provided, insert into each of the keyhole
openings and tightly secure the unit against the bottom of the cabinet.
NOTE: Install more screws through the back of the unit if necessary.
e. Use the conversion collar for 8
f. Connect an 8
g. Finish off by sealing the connection point with aluminum tape.
2. WALL MOUNT INSTALLATION (OPTIONAL)
a. Optional RA35DC duct cover is required for wall mount installation.
b. Inspect the RA35DC for any sign of defect or damage. (ie. scratches,
dents, loose seams, etc.)
c. Be sure you have the following content.
ii. Screw packet
d. Determine the exact location you want to install the range hood.
e. Prepare back wall frame with cross wood support.
f. Install the hood mounting bracket to the back of the unit and secure it with
the (12) screws provided. (6 screws for each bracket) (Fig. 2a)
g. Mount the unit onto wall with mounting screws (not included) (Fig. 2b)
h. Use a spirit level to ensure the balance of the hood is true.
i. Install the exhaust piping and connect it to the outlet of the unit. (Fig. 2c)
j. Place the duct cover on top of the unit and secure it with the (7) duct
cover screws provided. (Fig. 2d)
INSTALLATION
i. One piece stainless steel duct cover