Unit Parts Identification; Controls; Operating Instructions - Kelvinator KWH20CRC User Manual

Unit parts identification

1 Front panel
2 Air filter
3 Frame
4 Cabinet
5 Air inlet grille (outdoor side)
6 Air outlet grille
7 Electronic control keypad
8 Power supply cord and plug
9 Remote control
1 2 3
1 Power cord conductors are distinguished according to
colour as follows (see Fig.1)
2 For your safety and protection, this unit is earthed
through the power cord (see Fig.2)
Please contact the manufacturer or its service agent or a
similar qualified person if you want to replace it.
3 Be sure that the unit is being correctly grounded. The
wall outlet (Air-Break Switch) should be provided with
reliable earth wire.
4 The unit should be provided with an individual circuit
and the circuit breaker/fuse rating should be the same as
that of the power cord and wall outlet.
Fig. 1
A
power
E
cord
N
E- earthwire, yellow/green
N- neutral wire, blue
A - active wire, brown
4
SLEEP SAVER
LIGHT ENERGY
OFF TIMER ON TIMER
SWING CLOCK
OFF ON
MODE FAN
CLOSE
Fig. 2
wall outlet
air break switch

Operating instructions

Controls

The electronic control keypad will look like one of the
following:
Reverse Cycle Models
S W IN
F A N
L O W
A U T O
F IL T E R
Cooling only models
5
S W IN
6
7 F A N
L O W
A U T O
8
F IL T E R
9
Vent control
The vent control is located above the control knobs.
The operation method is different on different models
(see the following figures).
For maximum cooling efficiency, CLOSE the vent.
This will allow internal air circulation.
To open the vent, pull the lever toward you To close it,
push it in.
CLOSE
VENT OPEN
To open the vent, set the lever to the right position
To close it, set the lever in the left position.
Kelvinator Air Conditioning unit parts identification/operation instructions 5
P O W E R
C O O L
D R Y
M O D
F A N
T IME R
P O W E R
C O O L
D R Y
M O D
F A N
T IME R
OPEN
close open