Panel Pcb Assy - Brother MFC-8460N Service Manual

5.1.56 Panel PCB ASSY

(1) Disconnect the connector of the Panel PCB harness from the Panel unit.
(2) Remove the four cup B M3x10 Taptite screws, release the two Hooks and remove the ALFB
panel.
Taptite, cup B M3x10
(3) Disconnect the connector of the Backlight module harness and LCD cable from the Panel
PCB ASSY.
NOTE:
- After disconnecting flat cable(s), check that each cable is not damaged at its end or short-
circuited.
- When connecting flat cable(s), do not insert them at an angle. After insertion, check that
the cables are not at an angle.
Taptite, cup B M3x10
Panel PCB harness
ALFB panel
2
Hook
Fig. 5-95
Backlight module harness
Panel PCB ASSY
Fig. 5-96
5-72
1
Panel unit
LCD cable
Hook
Confidential