Brother MFC-8460N Service Manual page 405

- Selectors 6 and 7: Dial tone detection in PABX (Not used.)
These selectors activate or deactivate the dial tone detection function which detects a dial tone
when a line is connected to the PABX.
Setting both of these selectors to "1" activates the dial tone detection function so that the machine
starts dialing upon detection of a dial tone when a line is connected.
Other setting combinations deactivate the dial tone detection function so that the machine starts
dialing after the specified WAIT (3.5, 5.0, or 7.0 sec.) without detection of a dial tone when a line
is connected.
Selector
No.
Earth function in transfer facility
1
(Not used.)
Dual tone detection frequency in
2
ICM recording
3
(Not used.)
Dual tone detection sensitivity in
4 ICM recording
(Not used.)
Added time to maximum OGM
recording time (WSW24 Selector 1,
2) and erasing time length of ICM
tone recorded preceding the tone
5
detection starting point in the case
of automatic line disconnection due
to no voice signal received
(WSW34 Selector 1 to 3).
6
| Break time length for flash function
8
NOTE: Selectors 1 and 5 through 8 are not applicable in those countries where no transfer facility is
supported.
NOTE: Selectors 2 through 4 are applicable to models equipped with built-in TADs.
- Selector 1: Earth function in transfer facility (Not used.)
This selector determines whether or not the earth function is added to the transfer setting menu to
be accessed by the function switch.
WSW04
(TRANSFER facility setting)
Function
App. 4-6
Setting and Specifications
0: Provided
No. 2 3
0 0 : 350 and 440 Hz (A)
0 1 : 440 and 480 Hz (B)
1 0 :
480 and 620 Hz (C)
1 1 :
0: Normal
0: Not added
1: +4 seconds added
No. 6 7 8
0 0 0 : 80 ms
0 0 1 : 100 ms
0 1 0 : 110 ms
0 1 1 : 120 ms
1 0 1 : 200 ms
1 0 1 : 250 ms
1 1 0 : 500 ms
1 1 1 : 700 ms
1: Not provided
1: High
Confidential