Joint Cover Assy - Brother MFC-8460N Service Manual

5.1.81 Joint Cover ASSY

(1) Disconnect the connector of the Battery.
(2) Remove the Battery. (for the model supporting the Battery only)
(3) Disconnect the connector of the Battery harness, and then remove the Battery harness from
the Main PCB.
CAUTION:
- There is a danger of explosion if the battery is incorrectly replaced.
- Use Brother genuine spare part when you replace the battery.
- Do not disassemble, recharge or dispose of in fire.
- Used battery should be disposed of according to local regulations.
Battery harness
Main PCB
(4) Remove the four bind B M4x12 Taptite screws from the Joint cover.
(5) Release all Hooks of the Joint cover and lift up the front side of the Joint cover.
(6) Pull out the Joint cover to the front side.
Hooks
Hook
Taptite, bind B M4x12
Battery
2
1
3
<Left side>
Fig. 5-152
6
Hook
Hook
Fig. 5-153
Main PCB
5
<Front side>
5-101
Joint cover
Taptite, bind B M4x12
Hook
Hook
Taptite, bind B M4x12
Confidential