Schwinn 125 Owner's Manual page 33

Console shuts off (enters
sleep mode) while in use
Fan will not turn on or will
not turn off
Unit rocks/does not sit
level
Pedals loose/unit difficult
to pedal
Clicking sound when
pedaling
Seat post movement
Check data cable integrity
Check data cable
connections/orientation
Reset Machine
Check magnet position
(requires shroud removal)
Check RPM Sensor
Check data cable integrity
Check data cable
connections/orientation
Reset Machine
Check leveler adjustment
Check surface under unit
Check pedal to crank con-
nection
Check crank to axle con-
nection
Check pedal to crank con-
nection
Check locking pin
Check adjustment knob
All wires in the cable should be intact. If any are cut or crimped,
replace cable.
Be sure cable is connected securely and oriented properly. Small
latch on connector should line up and snap into place.
Unplug unit from electrical outlet for 3 minutes. Reconnect to
outlet.
Magnet should be in place on pulley.
Contact Customer Care for further assistance.
All wires in cable should be intact. If any are cut or crimped,
replace cable.
Be sure cable is connected securely and oriented properly. Small
latch on connector should line up and snap into place.
Unplug unit from electrical outlet for 3 minutes. Reconnect to
outlet.
Leveling feet may be turned in or out to level bike.
Adjustment may not be able to compensate for extremely uneven
surfaces. Move bike to level area.
Pedal should be tightened securely to crank. Be sure connection
is not cross-threaded.
Crank should be tightened securely to axle.
Remove pedals and reattach fully.
Be sure adjustment pin is locked into one of the seat post adjust-
ment holes.
Be sure knob is securely tightened.
33