Page 1
3DTV Support Quick Installation Guide Introduction The 4x2 HDMI Matrix Switch with 3DTV Support allows any four HDMI sources to be displayed on any two displays and routes high definition video in multiple resolutions up to 1080p plus multi- channel audio.
Page 2
Layout Select 2 Output 2 LED Output 1 LED IR Receiver Select 1 Figure 1: Front Panel Layout • Select 1: Select input source 1, 2, 3 or 4 with Output 1 or press for 3 seconds to turn off Output 1 •...
Page 3
S/PDIF Out HDMI In 4 HDMI In 3 HDMI In 2 HDMI In USB port HDMI Out 2 HDMI Out 1 Power jack Figure 2 Rear Panel Layout • USB port: For firmware update only • Power jack: Connects to the included power adapter •...
Hardware Installation Power off all source devices and displays. Connect up to 4 HDMI source devices to the switch's HDMI input ports using HDMI cables (cables not included). Connect up to 2 HDMI displays to the switch's HDMI output ports using HDMI cables (cables not included).
Page 6
Operation Use the front panel push buttons or the IR Remote Control to select the sources and displays. Front Panel Push Button Selection See descriptions and instructions on page 2. IR Remote Control Selection See descriptions and instructions on page 2.
Page 7
Go to www.siig.com, click Support, then REQUEST A PRODUCT REPLACEMENT to submit a request to SIIG RMA or fax a request to 510-657-5962. Your RMA request will be processed, if the product is determined to be defective, an RMA number will be issued.
Page 8
Fremont, CA 94538-3152, USA Phone: 510-657-8688 4 x 2 HDMI Matrix Switch with 3DTV Support is a trademark of SIIG, Inc. SIIG and the SIIG logo are registered trademarks of SIIG, Inc. All other names used in this publication are for identification only and may be trademarks of their respective owners.
Need help?
Do you have a question about the 4x2 HDMI and is the answer not in the manual?
Questions and answers