Display Assembly And Display Latch - Dell Inspiron 2600 Service Manual

Back to Contents Page

Display Assembly and Display Latch

Dell™ Inspiron™ 2600 and 2650
Display Assembly
Display Latch
Display Assembly
NOTICE: You must remove the display assembly before you remove the palm rest.
NOTICE: Disconnect the computer and any attached devices from electrical outlets, and remove any installed battery.
NOTICE: To avoid ESD, ground yourself by using a wrist grounding strap or by touching an unpainted metal surface on the computer.
NOTICE: Read "Preparing to Work Inside the
1 top cover
2 M2.5 x 5-mm screws (2)
3 bottom case
1. Remove the keyboard.
2. Close the display assembly.
3. From the back of the computer, remove the two M2.5 x 5-mm screws labeled "circle D."
4. Open the display assembly approximately 180 degrees and support the display assembly so that it does not open past this position.
5. Remove the two M2.5 x 5-mm screws that secure the display-feed flex cable to the system board.
NOTICE: When reconnecting the display-feed flex cable connector to the system board, push down on the top left and right ends of the connector.
Pressing on the center of the connector may damage resistors and compromise EMI protection in the computer.
Computer" before performing the following procedure.