Palm Rest - Dell Inspiron 2600 Service Manual

1 bottom of video card
2 video card connector
3 system board
4 interface connector
5 power-board flex cable
6 memory module
3. Reinstall the M2.5 x 8-mm screw that secures the video card to the bottom case.
4. Replace the EMI shield.
5. Replace the keyboard.

Palm Rest

NOTICE: Disconnect the computer and any attached devices from electrical outlets, and remove any installed battery.
NOTICE: To avoid ESD, ground yourself by using a wrist grounding strap or by touching an unpainted metal surface on the computer.
NOTICE: Read "Preparing to Work Inside the
1. Remove the keyboard.
NOTICE: You must remove the display assembly before you remove the palm rest; the display hinges pass through the back of the palm rest.
2. Remove the display assembly.
3. Remove the EMI shield.
4. Remove the video card.
5. Remove the two M2.5 x 5-mm screws from the top of the palm rest.
1 M2.5 x 5-mm screws (2)
2 top of the palm rest
6. Turn the computer over and remove the twelve M2.5 x 8-mm screws labeled "circle P."
Computer" before performing the following procedure.