Memory Module - Dell Inspiron 2600 Service Manual

Back to Contents Page
Memory Module, Modem, Optical Drive, and Floppy Drive
Dell™ Inspiron™ 2600 and 2650
Memory Module
Modem
Optical Drive
Floppy Drive

Memory Module

Removing the Memory Module/Modem Cover
NOTICE: Disconnect the computer and any attached devices from electrical outlets, and remove any installed battery.
NOTICE: To avoid ESD, ground yourself by using a wrist grounding strap or by touching an unpainted metal surface on the computer.
NOTICE: Read "Preparing to Work Inside the
HINT: This procedure covers removing and replacing the memory module located under the memory module/modem cover on the bottom of the
computer. A second memory module resides on the upper surface of the system board under the EMI shield. To replace the memory module under the
EMI shield, perform the procedure for removing the
1. Turn the computer over, and remove the memory module/modem cover:
a. Remove the M2.5 x 5-mm screw from the memory module/modem cover.
b. Slide the cover out approximately 10 mm, and lift it away from the computer.
1 M2.5 x 5-mm screw
2 memory module/modem
cover
NOTICE: To prevent damage to the memory module connector, do not use tools to spread the inner metal tabs that secure the memory module.
2. If you are replacing a memory module, remove the existing module.
NOTICE: Handle memory modules by their edges, and do not touch the components on a module.
a. Use your fingertips to carefully spread apart the securing clips on each end of the memory module connector.
The module should pop up.
b. Remove the module from the connector.
Computer" before performing the following procedure.
EMI shield. Then replace the memory module.