Display Assembly And Display Latch; Display Assembly; Removing The Display Assembly - Dell XPS M140 Service Manual

Hide thumbs Also See for XPS M140:

Table of Contents

Display Assembly and Display Latch

CAUTION:

Before you perform any of the procedures in this section, follow the safety instructions in the

Product Information Guide

NOTICE:

To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically

touching an unpainted metal surface (such as the back panel) on the computer.

1 Follow the instructions in "Preparing to Work Inside the Computer" on page 7.

2 Remove the hinge cover (see "Removing the Hinge Cover" on page 41).

3 Remove the keyboard (see "Removing the Keyboard" on page 43).

4 Open the display all the way (180 degrees) so that it rests flat against your work surface.

5 Use the pull-tab to disconnect the display cable from the system board.

6 Remove the Mini PCI antenna cables from the retaining clips on the base of the computer and

pull apart the connectors.

7 Remove the four M2.5 x 5-mm screws (two on each side) that connect the display assembly to the

computer.

8 Lift the display assembly straight out of the computer.

Display Assembly and Display Latch

Table of Contents