Back to Contents Page
Display Assembly and Display Latch
Dell™ Inspiron™ 600m Service Manual
Display Assembly
Display Bezel
Display Panel
Display Latch
Display Assembly
CAUTION:
NOTICE:
as the back panel) on the computer.
NOTICE:
1. Follow the instructions in
2. Remove the keyboard.
3. Open the display assembly approximately 180 degrees, and support the display assembly so that it does not open past this position.
4. Loosen the captive screw that secures the display cable to the system board, and release the cable from the four cable-routing clips.
1 display
2 cable-routing clips (4)
3 display cable connector
5. Pull up on the pull-tab that is attached to the display cable connector to remove the connector from the system board.
6. Remove the three M2.5 x 6-mm screws.
7. Rotate the display assembly to a 90-degree angle, and lift the display assembly up and out of the computer base.
Great user manuals database on
Before performing the following procedures, read the safety instructions in your Owner's Manual.
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such
You must remove the display assembly before you remove the palm rest.
"Preparing to Work Inside the
UserManuals.info
Computer."