Removing The Display Bezel - Dell Inspiron 2600 Service Manual

1 screw covers (5) 6
2 M2.5 x 5-mm screws (5) 7
3 display bezel 8
4 display panel 9
5 M2.5 x 5-mm screws (2) 10 top cover

Removing the Display Bezel

NOTICE: Disconnect the computer and any attached devices from electrical outlets, and remove any installed battery.
NOTICE: To avoid ESD, ground yourself by using a wrist grounding strap or by touching an unpainted metal surface on the computer.
NOTICE: Read "Preparing to Work Inside the
1. Remove the keyboard.
2. Remove the display assembly.
3. Use a plastic scribe to pry the five screw covers out of the screw holes located on the front of the bezel.
4. Remove the five M2.5 x 5-mm screws located on the front of the bezel.
NOTICE: Carefully separate the bezel from the top cover to avoid damage to the bezel.
5. Starting at the bottom of the display panel (by the Dell™ logo), use your fingers to separate the bezel from the top cover by lifting the inside of the
bezel while pushing in on the outside.
Removing the 14-Inch Display Panel
NOTICE: Disconnect the computer and any attached devices from electrical outlets, and remove any installed battery.
NOTICE: To avoid ESD, ground yourself by using a wrist grounding strap or by touching an unpainted metal surface on the computer.
NOTICE: Read "Preparing to Work Inside the
1. Remove the keyboard.
M2 x 3-mm screws (4)
M2.5 x 5-mm screw (1)
display-feed flex cable
flex-cable retention bracket
Computer" before performing the following procedure.
Computer" before performing the following procedure.