Dell Dimension 5100 Service Manual page 91
Hide thumbs
Also See for Dimension 5100:
- Owner's manual (162 pages) ,
- User manual (142 pages) ,
- Service manual (64 pages)
Table of Contents
Advertisement
10. Connect your computer and devices to electrical outlets, and turn them on.
Clearing CMOS Settings
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.
1. Follow the procedures in
"Before You
2. Reset the current CMOS settings:
a. Locate the 3-pin CMOS jumper (RTCRST) on the
b. Remove the jumper plug from pins 2 and 3.
c. Place the jumper plug on pins 1 and 2 and wait for approximately 5 seconds.
d. Replace the jumper plug on pins 2 and 3.
3. Close the
computer
cover.
NOTICE:
To connect a network cable, first plug the cable into the network port or device and then plug it into the computer.
4. Connect your computer and devices
Back to Contents Page
Begin."
system
board.
Advertisement
Table of Contents
