Dell Dimension 5100 Service Manual page 65

Installing a Floppy Drive
NOTE: If the new floppy drive does not include shoulder screws, use the screws within the drive panel insert.
1 drive
2 screws (4)
1. Follow the procedures in "Before You
2. Remove the computer cover.
3. Remove the drive panel.
NOTE: If you are installing a new drive, you need to remove the
4. Slide the drive into place until you feel a click or feel the drive securely installed.
5. Attach the power and data cables to the floppy drive.
6. Connect the other end of the data cable to the connector labeled "DSKT2" on the system board and route the cable through the clip on the shroud.
1 power cable
2 data cable
7. Check all cable connections and fold cables out of the way to avoid blocking the fan and cooling vents.
8. Replace the drive panel.
9. Replace the computer cover.
NOTICE: To connect a network cable, first plug the cable in to the network port or device and then plug it in to the computer.
10. Connect your computer and devices to their electrical outlets, and turn them on.
Begin."
drive-panel insert.