Installing A Pci Card - Dell Dimension 5100 Service Manual

If you are installing or replacing a card, follow the procedures in the next section. If you are removing but not replacing a PCI card, see
If you are replacing a card, remove the current driver for the card from the operating system.
If you are installing or replacing a PCI Express card, see

Installing a PCI Card

1. Follow the procedures in "Before You
2. Remove the computer cover.
1 release tab
2 card retention door
3. Gently push the release tab on the card retention door from the inside to pivot the door open. Because the door is captive, it will remain in the open
position.
4. If you are installing a new card, remove the filler bracket to create a card-slot opening. Then continue with step 6.
5. If you are replacing a card that is already installed in the computer, remove the card.
If necessary, disconnect any cables connected to the card. Grasp the card by its top corners, and ease it out of its connector.
6. Prepare the card for installation.
See the documentation that came with the card for information on configuring the card, making internal connections, or otherwise customizing it for your
computer.
CAUTION: Some network adapters automatically start the computer when they are connected to a network. To guard against electrical shock, be
sure to unplug your computer from its electrical outlet before installing any cards.
7. Place the card in the connector and press down firmly. Ensure that the card is fully seated in the slot.
"Installing a PCI Express
Begin."
Card."
"Removing a PCI Card."