Dell Dimension 5100 Service Manual page 115

Another failure has occurred.
The computer is in a normal operating
condition after POST.
NOTE: The diagnostic lights are not lit after
the system successfully boots to the
operating system.
Beep Codes
Your computer might emit a series of beeps during start-up if the monitor cannot display errors or problems. This series of beeps, called a beep code, identifies
a problem. One possible beep code (code 1-3-1) consists of one beep, a burst of three beeps, and then one beep. This beep code tells you that the computer
encountered a memory problem.
If your computer beeps during start-up:
1. Write down the beep code.
2. Run the Dell Diagnostics to identify a more serious cause.
3. Contact Dell for technical assistance (see your computer Owner's Manual for information about how to contact Dell).
Code Cause
1-1-2 Microprocessor register failure
1-1-3 NVRAM read/write failure
1-1-4 ROM BIOS checksum failure
1-2-1 Programmable interval timer failure
1-2-2 DMA initialization failure
1-2-3 DMA page register read/write failure
1-3 Video Memory Test failure
1-3-1 through 2-4-4 Memory not being properly identified or used
3-1-1 Slave DMA register failure
3-1-2 Master DMA register failure
3-1-3 Master interrupt mask register failure
3-1-4 Slave interrupt mask register failure
3-2-2 Interrupt vector loading failure
3-2-4 Keyboard Controller Test failure
3-3-1 NVRAM power loss
3-3-2 Invalid NVRAM configuration
3-3-4 Video Memory Test failure
3-4-1 Screen initialization failure
3-4-2 Screen retrace failure
3-4-3 Search for video ROM failure
4-2-1 No timer tick
4-2-2 Shutdown failure
4-2-3 Gate A20 failure
4-2-4 Unexpected interrupt in protected mode
4-3-1 Memory failure above address 0FFFFh
4-3-3 Timer-chip counter 2 failure
4-3-4 Time-of-day clock stopped
and Hardware Compatibilities" in your computer Owner's Manual).
4. If the problem persists, contact Dell (see your computer Owner's Manual for
information about how to contact Dell).
Ensure that the cables are properly connected to the system board from the hard
l
drive, CD drive, and DVD drive (see
If there is an error message on your screen identifying a problem with a device
l
(such as the floppy drive or hard drive), check the device to ensure that it is
functioning properly.
The operating system is attempting to boot from a device (such as the floppy drive
l
or hard drive); check system setup
the devices installed on your computer.
If the problem persists, contact Dell (see your computer Owner's Manual for
l
information about how to contact Dell).
None.
"System Board Components").
to ensure that the boot sequence is correct for