Addressing Memory With 4-Gb Configurations; Removing Memory; Installing Memory - Dell Dimension 5100 Service Manual

Hide thumbs Also See for Dimension 5100:
Table of Contents

Advertisement

NOTICE:
If you remove your original memory modules from the computer during a memory upgrade, keep them separate from any new modules that
you may have, even if you purchased the new modules from Dell. If possible, do not pair an original memory module with a new memory module.
Otherwise, your computer may not start properly. You should install your original memory modules in pairs either in DIMM connectors 1 and 2 or DIMM
connectors 3 and 4.
 

Addressing Memory With 4-GB Configurations

Your computer supports a maximum of 4 GB of memory when you use four 1-GB DIMMs. Current operating systems, such as Microsoft® Windows® XP, can
only use a maximum of 4 GB of address space; however, the amount of memory available to the operating system is less than 4 GB. Certain components
within the computer require address space in the 4-GB range. Any address space reserved for these components cannot be used by computer memory.
 

Removing Memory

 
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.
NOTICE:
To prevent static damage to components inside your computer, discharge static electricity from your body before you touch any of your
computer's electronic components. You can do so by touching an unpainted metal surface on the computer chassis.
 
1. Follow the procedures in
"Before You
 
2. Remove the
computer
cover.
 
3. Press out the securing clip at each end of the memory module connector.
 
4. Grasp the module and pull up.
If the module is difficult to remove, gently ease the module back and forth to remove it from the connector.
 

Installing Memory

 
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.
NOTICE:
To prevent static damage to components inside your computer, discharge static electricity from your body before you touch any of your
computer's electronic components. You can do so by touching an unpainted metal surface on the computer chassis.
 
1. Follow the procedures in
"Before You
 
2. Remove the
computer
cover.
 
3. Press out the securing clip at each end of the memory module connector.
1 memory connector closest to processor
2 securing clips (2)
3 memory connector
 
4. Align the notch on the bottom of the module with the crossbar in the connector.
Begin."
Begin."

Advertisement

Table of Contents
loading

Table of Contents