Dell Dimension 5100 Service Manual page 90

1. Enter system setup.
2. Use the arrow keys to highlight the Boot Sequence menu option and press <Enter> to access the menu.
NOTE: Write down your current boot sequence in case you want to restore it.
3. Press the up- and down-arrow keys to move through the list of devices.
4. Press the spacebar to enable or disable a device (enabled devices have a checkmark).
5. Press plus (+) or minus (–) to move a selected device up or down the list.
Clearing Forgotten Passwords
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.
1. Follow the procedures in "Before You
2. Locate the 3-pin password jumper (PSWD) on the
NOTE: When you receive your computer, the jumper plug is attached to pins 1 and 2.
3. Close the computer cover.
4. Connect your computer and monitor to electrical outlets, and turn them on.
5. After the Microsoft® Windows® desktop appears on your computer,
outlet.
6. Disconnect the computer power cable from the electrical outlet, and press the power button to ground the system board.
7. Open the computer cover.
8. Locate the 3-pin password jumper (PSWD) on the
9. Close the computer cover.
NOTICE: To connect a network cable, first plug the cable into the network port or device and then plug it into the computer.
Begin."
system board, and attach the jumper plug to pins 2 and 3 to clear the password.
shut down your
system board and attach the jumper to pins 1 and 2 to re-enable the password feature.
computer. Turn off the monitor and disconnect it from the electrical