Front Panel - ZyXEL Communications ZyWALL USG100-Plus User Manual

Chapter 1 Introduction

1.7 Front Panel

This section introduces the ZyWALL's front panel.
Figure 18 ZyWALL Front Panel
1.7.1 Front Panel LEDs
The following tables describe the LEDs.
Table 7 Front Panel LEDs
LED COLOR STATUS
PWR
Green
Red
SYS Green
Red
1, 2 ... Green
Orange
USB Green
Orange
P1~P5 Green
Orange
20
DESCRIPTION
Off The ZyWALL is turned off.
On The ZyWALL is turned on.
On There is a hardware component failure. Shut down the device, wait for a few
minutes and then restart the device (see
turns red again, then please contact your vendor.
Off The ZyWALL is not ready or has failed.
On The ZyWALL is ready and running.
Blinking The ZyWALL is booting.
On The ZyWALL xd an error or has failed.
Off There is no traffic on this port.
Blinking The ZyWALL is sending or receiving packets on this port.
Off There is no connection on this port.
On This port has a successful link.
Off No device is connected to the ZyWALL's USB port or the connected device is
not supported by the ZyWALL.
On A 3G USB card or USB storage device is connected to the USB port.
On Connected to a 3G network through the connected 3G USB card.
Off There is no traffic on this port.
Blinking The ZyWALL is sending or receiving packets on this port.
Off There is no connection on this port.
On This port has a successful link.
Section 1.5 on page 19). If the LED
ZyWALL USG100-PLUS User's Guide