ZyXEL Communications ZyWALL USG100-Plus User Manual page 81

4.6.5 Configuring L2TP VPN in iOS
To configure L2TP VPN in an iOS device, go to Settings > VPN > Add VPN Configuration > L2TP
and configure as follows. The example settings here go along with the L2TP VPN configuration
example in Section 4.6.1 on page
• Description is for the user to identify the VPN configuration.
• Server is the ZyWALL's WAN IP address.
• Account is the user's account for using the L2TP VPN (L2TP-test in this example).
• RSA SecurID leave this off.
• Password is the password for the user's account.
• Secret is the pre-shared key of the IPSec VPN gateway the ZyWALL uses for L2TP VPN over
IPSec (top-secret in this example).
• Send All Traffic leave this on.
• Proxy leave this off.
4.6.6 Configuring L2TP VPN in Windows
The following sections cover how to configure L2TP in remote user computers using Windows 7,
Vista, or XP. The example settings here go along with the L2TP VPN configuration example in
Section 4.6.1 on page
4.6.6.1 Configuring L2TP in Windows 7 or Windows Vista
Do the following to establish an L2TP VPN connection.
Create a Connection Object
Open the Network and Sharing Center screen.
1
Windows 7: click Start > Control Panel > View network status and tasks > Set up a new
connection or network.
Windows Vista: click Start > Network > Network and Sharing Center > Set up a connection
or network).
Select Connect to a workplace and click Next.
2
Select Use my Internet connection (VPN).
3
For the Internet address enter the My Address domain name or WAN IP address of the VPN
4
gateway the ZyWALL is using for L2TP VPN (172.16.1.2 in this example).
For the Destination name, specify a name to identify this VPN (L2TP to ZyWALL for
4a
example).
Select Don't connect now, just set it up so I can connect later and click Next.
4b
ZyWALL USG100-PLUS User's Guide
75.
75.
Chapter 4 Create Secure Connections Across the Internet
81