ZyXEL Communications ZyWALL USG100-Plus User Manual page 41

2.7.5 Testing the IPv6-in-IPv4 Tunnel
Connect a computer to the ZyWALL's LAN1.
1
Enable IPv6 support on you computer.
2
In Windows XP, you need to use the IPv6 install command in a Command Prompt.
In Windows 7, IPv6 is supported by default. You can enable IPv6 in the Control Panel > Network
and Sharing Center > Local Area Connection screen.
You should get an IPv6 IP address starting with 2003:1111:1111:1000:.
3
Use the ping -6 [IPv6 IP address] command in a Command Prompt to test whether you can
4
ping a computer behind ZyWALL Y. You should get a response.
ZyWALL USG100-PLUS User's Guide
Chapter 2 How to Set Up Your Network
41