Gs728Tpp Front Panel And Back Panel Configuration - NETGEAR ProSafe GS728TP Hardware Installation Manual

• Recessed Factory Defaults button to restore the device back to the factory defaults.
• Select button to change the working mode of the port LEDs with either PoE mode or
Ethernet mode.
• Port Status and Port Speed LEDs.
• Power, Fan Status, Max PoE, and LED Mode LEDs.
Figure 5 illustrates the NETGEAR GS728TPP Gigabit Smart Switch back panel.
Figure 5. Back panel
The back panel contains a power connector.

GS728TPP Front Panel and Back Panel Configuration

The GS728TPP Gigabit Smart Switch has 24 10/100/1000 Mbps copper ports and four
dedicated 100/1000 Mbps SFP fiber ports.
Each port is capable of sensing the line speed and negotiating the duplex mode with the link
partner automatically.
Figure 6 illustrates the front panel of the GS728TPP Gigabit Smart Switch.
Power, Fan, PoE Max,
and LED Mode LEDs
Factory
Defaults button
Reset button
Figure 6. Front panel
GS752TP, GS728TP, and GS728TPP Gigabit Smart Switch
Link/ACT LEDs
12
Power connector
SFP ports