Reset Button; Factory Defaults Button; Select Button - NETGEAR ProSafe GS728TP Hardware Installation Manual

GS752TP, GS728TP, and GS728TPP Gigabit Smart Switch

Reset Button

The Smart Switch has a Reset button on the front panel to allow you to manually reboot the
switch. This action is equivalent to powering the unit off and back on. The last saved
configuration is loaded into the switch as it resets. To operate the Reset button, insert a
device such as a paper clip into the opening to press the recessed button. The front-panel
LEDs turn off and light again as the switch performs its power-on self-test (POST).

Factory Defaults Button

The Smart Switch has a Factory Defaults button on the front panel so that you can remove
the current configuration and return the device to its factory settings. When you press the
Factory Defaults button, all settings including the password, VLAN settings, and port
configurations are removed. To operate the Factory Defaults button, insert a device such as
a paper clip into the opening to press the recessed button for over 2 seconds.

Select Button

LED Mode Select button on the front panel enables you to change the LED mode of the ports
between Ethernet and PoE status. You need to press the button for more than 1 second to
change the LED mode.
17