Increasing Memory - Intermec CV60 User Manual

Chapter 5 — Upgrading, Troubleshooting, and Cleaning the CV60

Increasing Memory

54 CV60 Vehicle Mount Computer With Windows XP/XPE User's Manual
7 Attach the IDE cable to the hard drive and secure the hard
drive to the hard drive bracket with the four screws that were
removed in Step 5.
8 Attach the IDE cable to the CV60 and attach the cable cover
that you removed in Step 4.
9 Close the CV60.
The CV60 comes with 256 MB of SDRAM which is expandable
to 512 MB.
To install memory into the CV60
1 Using a Phillips screwdriver, remove the ten screws that secure
the rear cover to the CV60. This will expose the memory slot.
2 Take your new memory module and insert it into the memory
slot.
3 Push down on the memory module until the two metal
contacts clamp onto the memory module.
4 Attach the rear coverwith the ten screws that you had
removed in Step 1.
Note: The SODIMM slot (Single Outline Dual Inline Memory
Module) allows upgrading the base memory from 256 MB to 512
MB with an Intermec approved SDRAM card.
Memory slot