NordicTrack 29835.0 User Manual page 9

7. While a second person lifts the back of the Right
Pedal Plate (14), insert the Right Pedal Bracket
(133) into the Right Pedal Arm (58).
Attach the Right Pedal Bracket (133) with an
M10 x 20mm Screw (91) and an M10 x 25mm
Washer (134). Do not overtighten the Screw;
the Right Pedal Bracket must turn freely.
Repeat this step on the other side of the
elliptical.
8. Identify the Right Pedal (49), which is marked
with a "Right" sticker, and orient it as shown.
While a second person lifts the Right Pedal Plate
(14), attach the Right Pedal (49) to the Right
Pedal Plate with four M6 x 16mm Screws (103)
and four M6 Washers (90). Tip: It may be help-
ful to lift the Right Pedal Arm (58).
Attach the Left Pedal (12) to the Left Pedal
Plate (not shown) in the same way.
9. Apply grease to a Medium Axle (119) and to two
M8 x 22mm Washers (97).
Identify the Right Link Arm (59), which is marked
with a "Right" sticker, and orient it as shown.
Insert the Medium Axle through the Right Link
Arm (59) and the Right Pedal Arm (58).
Tighten an M8 x 23mm Button Screw (82), an
Axle Cover (55), and an M8 x 22mm Washer
(97) into each end of the Medium Axle (119) at
the same time. To avoid damaging the plas-
tic, do not overtighten the Button Screws.
Repeat this step on the other side of the
elliptical.
7
91
134 14
58
8
49
14
12
58
90
103
9
82
55
97
58
9
133
90
103
59
119
97
55
82
Grease