NordicTrack 29835.0 User Manual page 25

Locate the Reed Switch (38). Loosen, but do not
remove, the two M4 x 12.7mm Flange Screws (161).
38
161
Next, rotate the Large Pulley (19) until a Magnet (43)
is aligned with the Reed Switch (38). Slide the Reed
Switch slightly toward or away from the Magnet. Then,
retighten the M4 x 12.7mm Flange Screws (161).
Rotate the Large Pulley (19) for a moment. Repeat
these actions until the console displays correct
feedback.
When the reed switch is correctly adjusted, reattach
the pulley cover, reconnect the wires if necessary, and
reattach the shield cover and center shield assembly.
HOW TO ADJUST THE DRIVE BELT
If you can feel the pedals slip while you are pedaling,
even when the resistance is adjusted to the highest
setting, the large drive belt may need to be adjusted.
To adjust the large drive belt, you must first remove the
Shield Cover (75) and the Center Shield (76) (see the
instructions below).
Remove the two indicated M4 x 16mm Screws (101)
from the Center Shield (76). Next, using a flat screw-
driver, release the tabs on the sides and rear of the
Shield Cover (75). Then, slide the Center Shield and
the Shield Cover forward.
19
43
Next, tighten the M8 Nut (122) on the J-bolt (139) one
half turn.
Reattach the shield cover and the center shield. If the
pedals still slip while you are pedaling, repeat these
steps.
If you have a question about drive belt adjustment,
see the front cover of this manual.
25
75
101
122
139
76