Snmp User Table - D-Link DES-3010F Manual

DES-3010F/DES-3010FL/DES-3010G/DES-3018/DES-3026 Fast Ethernet Switch Manual

SNMP User Table

The SNMP User Table displays all of the SNMP User's currently configured on the Switch.
In the SNMP Manager folder, located in the Administration folder, click on the SNMP User Table link. This will open
the SNMP User Table, as shown below.
To delete an existing SNMP User Table entry, click the
wish to delete.
To display the detailed entry for a given user, click on the hyperlinked User Name. This will open the SNMP User Table
Display page, as shown below.
The following parameters are displayed:
Parameter
User Name
Group Name
SNMP Version
Auth-Protocol
Priv-Protocol
Figure 6- 17. SNMP User Table
Figure 6- 18. SNMP User Table Display
Description
An alphanumeric string of up to 32 characters. This is used to identify the SNMP
users.
This name is used to specify the SNMP group created can request SNMP messages.
V1 - Indicates that SNMP version 1 is in use.
V2 - Indicates that SNMP version 2 is in use.
V3 - Indicates that SNMP version 3 is in use.
None - Indicates that no authorization protocol is in use.
MD5 - Indicates that the HMAC-MD5-96 authentication level will be used.
SHA - Indicates that the HMAC-SHA authentication protocol will be used.
None - Indicates that no authorization protocol is in use.
DES - Indicates that DES 56-bit encryption is in use based on the CBC-DES (DES-
below the Delete heading corresponding to the entry you
47