D-Link DES-3010F Manual page 124

DES-3010F/DES-3010FL/DES-3010G/DES-3018/DES-3026 Fast Ethernet Switch Manual
Parameter
Profile ID
Mode
Access ID
Type
VLAN Name
Source IP
Destination IP
Port
To view the settings of a previously correctly configured rule, click
screen:
The following window is the CPU Interface Filtering Rule Table for Packet Content.
Description
This is the identifier number for this profile set.
Select Permit to specify that the packets that match the access profile are forwarded by
the Switch, according to any additional rule added (see below).
Select Deny to specify that packets that do not match the access profile are not
forwarded by the Switch and will be filtered.
Type in a unique identifier number for this access. This value can be set from 1 - 5.
Selected profile based on Ethernet (MAC Address), IP address or Packet Content.
Ethernet instructs the Switch to examine the layer 2 part of each packet
•
header.
IP instructs the Switch to examine the IP address in each frame's header.
•
Packet Content Mask instructs the Switch to examine the packet header.
•
Allows the entry of a name for a previously configured VLAN.
Source IP Address - Enter an IP Address mask for the source IP address.
Destination IP Address- Enter an IP Address mask for the destination IP address.
The Access Rule may be configured on a per-port basis by entering the port number of
the Switch into this field. Entering all will denote all ports on the Switch.
Figure 9- 12. CPU Interface Filtering Rule Display - IP
in the Access Rule Table to view the following
111