Assembly; M10 Nylon - Weider WEBE1057.0 User Manual

ASSEMBLY

Make Assembly Easier
Everything in this manual is designed to ensure
that the weight bench can be assembled suc-
cessfully by almost anyone. By setting aside
plenty of time, assembly will go smoothly.
Before beginning assembly, carefully read the fol-
lowing information and instructions:
• To hire an authorized service technician to
assemble the weight bench, call 1-800-445-2480.
• Assembly requires two persons.
• Because of its size, the weight bench should be
assembled in the location where it will be used.
Make sure that there is enough clearance to walk
around the weight bench as you assemble it.
• Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until assembly is completed.
1.
Before beginning assembly, read the impor-
tant information in the box above. See the
PART IDENTIFICATION CHART on page 5
for help identifying small parts.
Orient the Frame Bumper (26) with the high end
in the position shown. Attach the Frame Bumper
to the Frame (1) with an M4 x 16mm Self-tapping
Screw (37) and an M4 Washer (42).
2. Attach the Frame (1) to the Crossbar (2) with
three M10 x 95mm Bolts (28) and three M10
Nylon Locknuts (40). Do not tighten the Nylon
Locknuts yet. Note: Use a rubber mallet to align
the holes in the Frame with the holes in the
Crossbar.
• Tighten all parts as you assemble them, unless
instructed to do otherwise.
• As you assemble the weight bench, make sure all
parts are oriented as shown in the drawings.
• For help identifying small parts, use the PART
IDENTIFICATION CHART on page 5.
• Assembly requires the included hex key(s)
and the following tools (not included):
two adjustable wrenches
one rubber mallet
one standard screwdriver
one Phillips screwdriver
Assembly may be more convenient if you have a
socket set, a set of open-end or closed-end
wrenches, or a set of ratchet wrenches.
1
2
28
40
1
40
6
37
42
High End
26
1
2
28