Installing The Storage Controller Card/Pcie Extender Card - Dell PowerEdge M820 Systems Owner's Manual

Figure 25. Removing and Installing a PCIe Extender Card
1. PCIe extender card
2. screws (2)
3. connector
4. tab

Installing The Storage Controller Card/PCIe Extender Card

1. Holding by its edges, position the storage controller card/PCIe extender card so that the card-connector aligns with
the system board connector.
2. Adjust the other end of the card so that the card edge is secured to the bracket.
When correctly seated:
– the storage controller card is secured under the tabs on the support bracket.
– the notch on the PCIe extender card is securely aligned with the corresponding tab on the support bracket.
3. Insert the card connector firmly into the system board connector until the card is fully seated.
4. Install the two screws to secure the storage controller card/PCIe extender card to the system board.
5. Reinstall the system board.
6. Install the blade in the enclosure.
5. support bracket
6. notch
65