Gateway Rear Panel - NETGEAR CG4500BDv2 User Manual

LED Description
Green indicates 1,000 Mbps. Amber indicates 100/10 Mbps.
•
LAN (Ethernet)
•
•
•
•
•
Wireless
•
On/Off
Pressing this button opens a 2-minute window for the gateway to connect with other
WPS-enabled devices. The LED blinks during this 2-minute period. For more information,
about using the WPS method to implement security, see the
Wireless Setup
WPS

Gateway Rear Panel

Figure 2. Gateway rear panel
The rear panel includes the following connectors, viewed from left to right:
• Four Gigabit Ethernet LAN ports. To connect local computers, use these ports.
• USB port. The USB port is a USB host and can be used for connecting a USB hard drive,
flash drive, or printer.
• Reset. To set the gateway to the original factory settings, press and hold the Reset
button for over 7 seconds. See
• Coaxial cable connector. Attach a coaxial cable to the cable service provider's
connection.
• Power. Power adapter input.
NETGEAR DOCSIS 3.0 N900 Wireless Data Gateway
Solid. An Ethernet device is connected and powered on.
Blinking. Data is being transmitted or received on the Ethernet port.
Off. No Ethernet device is detected on the Ethernet port.
Solid green. The wireless card is plugged in and enabled.
Blinking. There is traffic on the wireless card.
Off. The wireless card is either disabled or not plugged in.
To enable or disable the card (2.4Ghz and 5 GHz), press this button for 3 seconds.
on page 15.
Ethernet LAN ports
Factory Default Settings
Connecting to the Internet
Reset
USB
button
port
connector
on page 48.
7
Use Push 'N' Connect (WPS)
Coaxial
cable Power
adapter input