Heritage Kayaks Heritage Series User Manual page 95

Command Sets for Command Line Interface
90
RPORT provided the protocol type (UDP or TCP) is appropriate.
They are also displayed in place of port numbers, when a suitable
mapping exists.
" " should be either "
<protocol>
that is not very useful. For "
format as //isfs/services, which is the same as the output from
" ". The "
portname list
by " ".
ip help
Configuration saving saves this information.
Example:
DSL> ip portname flush
DSL> ip portname add someport 105/tcp
DSL> ip portname list
someport 105/TCP
DSL> ip portname read //isfs/services
DSL> ip portname list
router 520/UDP
snmp 161/UDP
tftp 69/UDP
telnet 23/TCP
someport 105/TCP
17. relay
Syntax:
relay
relay all | <i/f> [<i/f>] [forward]
Description:
Displays or sets what forwarding TCP/IP will do between interfaces.
The combinations of setting forwarding can be a bit confusing; they
behave as follows:
Command:
relay all
relay if1
relay if1 forward
relay if1 if2
relay if1 if2 forward
(Don't confuse the "forward" keyword, which indicates one-way
relaying, with the term "forwarding"!)
" or " "; it can be omitted, but
UDP TCP
", the file is in the same
portname read
" command is "
portname
Enables forwarding:
from every interface to every
non-loopback interface
from if1 to every non-loopback interface,
and from every interface to if1
from if1 to every non-loopback interface
from if1 to if2 and from if2 to if1
from if1 to if2
", not shown
hidden