Hardware Installation - Heritage Kayaks Heritage Series User Manual

Installing and Configuring your ADSL Router
14

2.2 Hardware Installation

Before start to configure your Router, you have to complete all the
hardware installation. The following steps provide instructions for
installing your Router.
1. Be sure the power switch on the right side of the Router is at the
OFF status.
2. Connect the power adaptor to the power jack that marked Power
at the rear panel of the Router, then plug in the DC power
adaptor to the wall electrical outlet.
3. Connect the 10Base-T cable.
A) If connect to computer directly
Connect one end of 10Base-T Ethernet straight-through
cable to the Ethernet port on your computer, then connect
the other end of 10Base-T Ethernet straight-though cable to
the connector that marked 10Base-T at the rear panel of the
Router.
B) If connect to more than one computer via Hub
Connect one end of 10Base-T Ethernet straight-through
cable (If your up-link hub without cascade switch, please
use a 10Base-T Ethernet crossover cable instead) to the
uplink port on the Ethernet Hub, then connect the other
end of 10Base-T Ethernet cable to the connector that
marked 10Base-T at the rear panel of the Router.
4. Connect one end of RJ11 telephone cable to the ADSL line jack
that marked ADSL at the rear panel of the Router, then connect
the other end of RJ-11 telephone cable to the ADSL service port
that your ADSL service provider or ISP installed.
5. Connect the male (9 pin) end of the RS-232 serial cable to the
connector that marked Console port at the rear panel of the
Router, then plug the other end of the RS-232 serial cable to the
RS-232 serial port of your computer.
6. Turn on the power switch. The Router should perform a self-test,
and then be ready for use.