Commands For Ppp Process - Heritage Kayaks Heritage Series User Manual

Command Sets for Command Line Interface
102

Commands for PPP process

1. Console object types
The ppp process presents its setup in terms of a number of distinct
object types:
The upper limit on the number of each of these objects permitted in a
system is configured using the
The current state of each object is saved by
1.1 Channels
The ppp process provides a number of PPP connection channels. A
channel is a single PPP connection. Channels are numbered from 1.
Many ppp console commands affect only a single channel. The
command is prefixed with the channel number.
1.2 Users
A user is a user name and password. All users must have distinct
names. The console command controls these.
user
1.3 Interfaces
An interface is an internal MAC (Ethernet) device. PPP channels must
be associated with an interface to be involved with bridging or
routing.
1.4 Interface 1 and Channel 1
Interface 1 has some special functions associated with it, allowing
dynamic IP address assignment to be performed. Channel 1 is by
default associated with Interface 1 These two should be used only for
IP dial-out functions, and for this function should be attached to the
router interface named 'ppp_device'.
2. <channel> clear
Syntax:
<channel> clear
Description:
Clear all aspects of this channel back to their default settings. If there
is an active connection it is torn down.
e' console command.
'config resourc
'config sav e'.