Kärcher B 95 RS Instruction Manual page 23

Brushes do not turn
No or very little detergent so-
lution gets added
The cleaning head does not
remain lowered.
Rectify faults
Ventilate the detergent solution pump
Fill up fresh water reservoir.
Unscrew the filter cup of the fresh water
filter and check for water leaking.
Description
Battery changing kit
Battery *
Charger *
* Only suited for appliances with maintenance-free batteries (gel).
Description
Disk brush, blue (medium, standard) 8.600-018.0 For cleaning slightly dirtied or sensitive floors.
Disk brush, grey (hard)
Driver plate
Disc pad, red (medium)
Disc pad, green (hard)
Disc pad, black (very hard)
Description
Brush roller, red (medium, stand-
ard)
Brush roller, white (soft)
Brush roller, orange (high/ low)
Brush roller, green (grit)
Brush roller, black (very hard)
Pad roller shaft
Roller pad, white (very soft)
Roller pad, red (medium)
Roller pad, green (hard)
Roller pad, yellow (soft)
Reset fuse of brush drive.
Check the brushes for blockage due to foreign particles, remove them if found.
Check level of detergent solution in the fresh water tank; refill, if required.
Open locking tap for fresh water.
Air in the pump for detergent, ventilate pump (see "Clearing faults").
Select a more intensive cleaning program.
Check fresh water sieve and filter; clean if required.
Install the brushes.
If there is no water leaking out, clean
the filter insert.
Tighten the filter cup.
Pull the suction hose off the cover of the
dirt water reservoir.
Start the cleaning process.
Accessories
Part no.: Description
8.601-121.0 consists of: battery trough, cable set, locking set, 2
transport cars
6.654-141.0 12V/105 A, maintenance-free (Gel),
6.654-229.0 36V, for maintenance-free batteries
Accessories BD 60/95 RS
Part no.: Description
8.600-020.0 For cleaning heavily dirtied floors.
8.600-017.0 For intake of pads.
6.369-826.0 For cleaning slightly dirtied floors.
6.369-827.0 For cleaning heavily dirtied floors.
6.369-828.0 For cleaning heavily dirtied floors.
Accessories B 95 RS with R 65 cleaning head
Part no.: Description
6.906-935.0 Also for regular cleaning of heavily dirtied floors.
6.906-981.0 For polishing and cleaning sensitive floors.
6.906-982.0 For scrubbing structured floors (safety tiles, etc.).
6.906-983.0 For thoroughly cleaning heavily dirtied floors and for
removing the coating (for e.g. of wax, acrylate).
6.906-984.0 For thoroughly cleaning heavily dirtied floors and for
removing the coating (for e.g. of wax, acrylate).
4.762-433.0 For intake of roller pads.
6.369-389.0 For fine-polishing floors.
6.369-456.0 For cleaning slightly dirtied floors.
6.369-455.0 For cleaning normal to heavily dirtied floors.
6.369-454.0 For polishing floors.
EN 10
-
Operator
Operator
Operator
Operator
Operator
Operator
Operator
Operator
At the latest after 2 minutes, detergent
solution should be emitted.
Insert the suction hose into the cover of
the fresh water reservoir.
Piece Machine
requires
piece
1 1
1 3
1 1
Piece Machine
requires
piece
1 2
1 2
1 2
5 2
5 2
5 2
Piece Machine re-
quires piece
1 2
1 2
1 2
1 2
1 2
1 2
20 96
20 96
20 96
20 96
23