Kärcher B 95 RS Instruction Manual page 21

Open the clamping lock and remove the
strap.
Take out the vacuum lips.
Note
The vacuum lips can be turned thrice till all
edges are worn off. After that you need a
new vacuum lip.
Turn the vacuum lip or replace and in-
sert it back into the vacuum bar and
align.
Insert the strap and close the clamping
lock. The tension must just be sufficient
to hold the vacuum lip without wrinkling.
Adjust the clamping lock, as required.
Mount splash guard
Lower the cleaning head.
Turn key to "0" and remove it.
1 Stopper
Loosen the end and adjust it in such a
way that the lower edge of the spray
guard is approx. 3 mm from the floor.
Tighten the stopper.
Replacing the Disk Brushes
1 side spray guard
Lift the cleaning head.
Turn key to "0" and remove it.
Raise the side spray guard and remove
it from the side.
Turn the unlocking lever of the sliding
brush in an anti-clockwise direction -
the brushes will fall downward and can
be pulled outward at the bottom of the
device.
Hold the new brush under the cleaning
head.
Turn the unlocking lever of the sliding
brush in clockwise direction and press
the brush upward.
Release the unlocking lever and check
that the brush is sitting properly.
Replace the spray-guard.
Repeat process on the opposite side.
Maintenance tasks - all types
Cleaning the floater
1 Pipe
2 Sieve with floater ball
Clean the sieve from the outside and
rinse it.
Check the mobility of the floater ball.
If it is too dirty:
Hold the pipe firmly and pull out the
sieve from the pipe.
Clean sieve and ball.
Hold the pipe firmly and reinsert the
sieve.
Clean the fresh water filter
1 Fresh water filter
2 Locking valve for fresh water
Close locking tap of fresh water.
Unscrew the filter cup.
Clean filter inlay or replace if too dirty.
Replace the filter cup.
Open locking tap.
Frost protection
In case of danger of frost:
Empty the fresh and dirt water reser-
voirs.
Store the appliance in a frost-protected
room.
EN 8
-
21