Please read and comply with Function Environmental protection these original instructions prior The scrubber vacuum is used for wet to the initial operation of your appliance and The packaging materials are re- cleaning or polishing of level floors. store them for later use or subsequent own- cyclable.
Operating and Functional Elements 1 Vacuum bar lowering lever 24 Fresh water level display Operator console 2 Cover waste water tank 25 Pedal for raising/ lowering the cleaning 3 Holding rail for home base head 4 Protective turbine strainer (under the 26 Lever to adjust the brush contact pres- float) sure...
– Use safety glasses while handling bat- Program selection switch Charging battery tery acid and follow the safety instruc- Note: tions to avoid personal injury or damage The device is equipped with a safety mech- to clothes. anism to prevent total discharge, i.e. when –...
Inclination Operation Routine cleaning of glossy RM 755 es surfaces (e.g. granite) If the vacuum result is unsatisfactory the in- DANGER clination of the straight vacuum bar can be Routine cleaning and basic RM 69 ASF Risk of injury. Push the pedal for raising/ modified.
cleaning is not done at an angle of 90 For a quicker emptying process, re- Brush trailing degrees to the joints. move the entire lid. Adjust the trailing time of the brushes. – The inclined position and the inclination To rinse the fresh water reservoir, re- ...
Page 8
Close the cover of the wastewater res- Monthly Maintenance schedule ervoir until it rests on the flexible lock. Check battery poles for oxidation, brush Maintenance intervals Open the water supply and rinse the off if necessary. Ensure that the con- Recommended cleaning processes are wastewater reservoir for about 30 sec- nection cable sits firmly.
Page 9
Connect the mains supply cable of the Replacing the brush rollers Fire, sparks, naked flames and cleaning head to the appliance. smoking must be strictly avoided Lift the cleaning head. Attach the terminal strip cover. Connect the hose couplers on the Danger of chemical burns cleaning head to the hose on the appli- ance.
Installation sketch for 2 batteries Installation sketch for 4 batteries Swivel the water reservoir all the way down, check the lock. Note: Charge the batteries before commissioning the appliance. See also "Charging the batteries". Removing the batteries CAUTION R isk of damage due to tipping appliance; remove batteries only if the appliance is equipped with a cleaning head.
Faults DANGER Risk of injury! Before working on the appli- ance, remove the Intelligent Key and the mains plug of the charger. Drain and dispose of the dirt water and the residual fresh water. Faults with display Display Remedy ERR_I_BÜRSTE_049 Check if foreign matters block the brushes;...
Accessory B 60 BR appliances B 60 W Bp (brush roller accessories) Description Part no.: Part no.: Description Working Working width width 650 mm 550 mm Brush roller, red (medium, standard) 6.906-934.0 6.906-935.0 Also for regular cleaning of heavily dirtied floors.