Installation Requirements - Radyne DMD20 Installation And Operation Manual

DMD20/20LBST Universal Satellite Modem
2.2

Installation Requirements

The modem is shipped fully assembled. It does not require removal of the covers for any
purpose in installation. The power supply itself is designed for universal application using from
100 to 240 VAC, 50 to 60 Hz, 1.0A.
There are no user-serviceable parts or configuration settings located inside
the Chassis. There is a potential shock hazard internally at the power supply
module. DO NOT open the Chassis under any circumstances.
WARNING
The unit contains a Lithium Battery. DANGER OF EXPLOSION exists if the
battery is incorrectly replaced. Replace only with the same or equivalent type
recommended by the manufacturer. Dispose of used batteries in accordance
WARNING
with local and national regulations.
Before initially applying power to the unit, it is a good idea to disconnect the
transmit output from the operating ground station equipment. This is
especially true if the current configuration settings are unknown, where
CAUTION
incorrect settings could disrupt existing communications traffic.
MN-DMD20-20LBST Revision 14
Installation
2–2