Initial Configuration Check - Radyne DMD20 Installation And Operation Manual

DMD20/20LBST Universal Satellite Modem
2.5

Initial Configuration Check

The is shipped from the factory with preset factory defaults. Upon initial power-up, a user check
should be performed to verify the shipped modem configuration. Refer to Section 4, User
Interfaces to locate and verify that the following configuration settings are correct:
Transmit (Tx) and Receive (Rx) Interface types are dependent upon the
customer's order.
IMPORTANT
Implementing Strap Code 26 can set the following modem configuration. Refer
to Table D-1 for an explanation and tabular listing of available Strap Codes.
The Frequency and Modulator Output Power are set independently of the strap
IMPORTANT
code.
MN-DMD20-20LBST Revision 14
connection at all times. Therefore, it is imperative during installation,
configuration, and operation that the user ensures that the unit has been
properly grounded using the ground stud provided on the rear panel of
the unit.
•
In Finland: "Laite on liitettävä suojamaadoituskoskettimilla
varustettuun pistorasiaan."
•
In Norway: "Apparatet må tilkoples jordet stikkontakt."
•
In Sweden: "Apparaten skall anslutas till jordat uttag."
Installation
2–4