Searching For A Component Code In Your Remote - Zektor HDS4.2 Owner's Manual

S 1
TEP
1 2 3
ZEKTOR
S 2
TEP
1 2 3
ZEKTOR
S 3
TEP
1 2 3
ZEKTOR

Searching for a component code in your remote

Assuming you do not have a remote listed in this user manual you will have to follow your remote
control's programming sequences to find a compatible component that the HDS4.2 understands, or
you can go to the section "Learning New Remote Codes" on page 9, to teach the HDS4.2 new keys
for individual commands.
To search for compatible component codes you must place the HDS4.2 in standby mode and try
manufacturer codes in your remote control until one of them causes the HDS4.2's IR indicator LED
to flash.
S 1
TEP
1 2 3
ZEKTOR
S 2
TEP
1 2 3
ZEKTOR
1 Place the HDS4.2 in standby mode. This is the factory default
mode on power up, and if it has not been changed, you can unplug
4
the HDS4.2 and plug it back in and it will power up in standby mode
(at this point only the power indicator light is lit and glowing RED).
If the HDS4.2 does not power up in standby mode, follow the steps
given in "Restoring the HDS4.2 to Factory Defaults" on page 14.
2 On your remote control press the buttons in the following
sequence, after each button press verify that the remote IR
4
indicator flashes. (If you make a mistake, you can start over by
pressing P
• P
OWER
• C
HANNEL
• P
OWER
• C
HANNEL
3 The HDS4.2 will power up indicating the new component codes
have been accepted.
4
1 Place the HDS4.2 in standby mode. This is the factory default
mode on power up, and if it has not been changed, you can unplug
4
the HDS4.2 and plug it back in and it will power up in standby mode
(at this point only the power indicator light is lit and glowing RED).
If the HDS4.2 does not power up in standby mode, follow the steps
given in "Restoring the HDS4.2 to Factory Defaults" on page 14.
2 Try different manufacturer codes until one of them causes the IR
indicator light on the HDS4.2 to blink when pressing the
4
P
OWER
HDS4.2 a new component code" on page 7, to teach the HDS4.2
to use the new component code.
twice.):
OWER
+
-
key. When found, go to back to "Teaching the
T
OGGLE
8