IDVIEW IV-110TX-SN Installation & Operation Manual page 53

5.2.1.4 Change the Record & Timer Properties
Via the Network
Follow the instructions below to reconfigure the
record and schedule recording settings via the
network.
Set the regular record settings
1. When in the single –device mode, click
to enter the SETUP page, (see the sample
screen as in A above)
2. Select a desired recording rate and Quality
from the corresponding drop-down list.
3. Click the OK button to proceed.
Set the Alarm record settings
1. When in the single –device mode, click
enter the SETUP page (see the sample screen
as in A above).
2. Set Alarm Setting to ON to enable the
drop-down list in the ALARM SETTING
area.
3.Select a desired recording rate and Quality
from the corresponding drop-down list.
4. Click the OK button to proceed.
Set the Record Schedule
1. When in the single –device mode, click
to enter the SETUP page (see the sample
screen as in B above).
2. Set the Record Schedule to ON to enable the
Record Schedule setting area.
3. Click the Time-Period button to set the schedule
for recording for each day. Go to both the Start
Time & End Time boxes, enter a specific Hour:
Minute and click Add button to add to the
Record List.
4. When all required settings are completed,
click OK to proceed.
51
to