Table of Contents
Advertisement
Press the Display button
will display the following sample message plus
the default display. Press the Display button
8
again; the unit will not display any OSD
message. Press the button one more time to
go back to the default display.
1+2 :59G
12.4 HR
QUALITY : BEST
NTSC
RATE :6HR
20 F/S
9K
MUX :ON
HD
SIZE
REC
1
20G
10.0%
2
39G
0.0%
CD
133M
80.0%
(For CD-RW model only)
IP : 192.168.1.90
14-04-2005 09:46:53
Total capacity of installed hard disk, 59 GB
(12.4 HR): Total 12.4 hour recording time available
(
): Timer record activated
(
): Alarm record activated
(
): motion detection activated
(QUALITY: BEST): Record quality setting, BEST
.
(NTSC ): NTSC system
(RATE: 6 HR): Setting of Record time mode, 6 hours
(20 F/S): Record speed setting, 20 fields/sec
Only connected to a single camera.
(MUX: OFF):
(
): Audio function activated
(
): Indicates which HDD is activated
.
( 9K ): The image file size
( HD ): Hard-disk compartment.(HD2 IS FOR
REMOVABLE MODEL ONLY)
(CD):CD-RW Compartment. (FOR CD-RW MODEL
ONLY)
( SIZE 20G): The capacity of the installed hard disk
( REC ): Percentage of system Recording
( PLAY ): Percentage of system Playback
( IP : 192 . 168 . 1 . 90 ): Network IP Address
192.168.1.90
(
)
.
: External signal
x
(
): Cannot operate now
8
once; the DVR
PLAY
0.1%
0.0%
(For removable HDD model only)
.
.
.
.
.
.
.
.
.
.
.
.
.
.
2.4 Updating System Software
Please take the following steps to safely update it.
1. Turn off the DVR.
2. Insert the SD card into the built-in SD slot of the
unit.
3. Hold down the Up
simultaneously, and then turn on the unit.
4. Keep holding down the buttons until the DVR
sounds a tone and display the message
" XXXXXX
BYTES READ" Now the DVR is
updating the system software, which will take
approximately 90 seconds to process.
5. Restart the unit when the device sounds a tone
twice and displays the message "PLEASE
RESTART". The process is complete.
(If you have already followed procedure 1~5 and
the unit is still unable to switch on, please first
check if the SD card you are using is functioning
and the file is intact. And then start procedures 1
~ 5 all over again.)
6. Verify the version of the system software. (Please
refer to section 4.6 VERSION.)
!
Caution
:
1. Before carrying out the updating procedures, please
ensure the SD card is working and the file of system
software is intact.
2. Don't interrupt the process while the unit is updating
itself, as this will cause the unit to crash.
12
12
and Down
13
buttons
Advertisement
Table of Contents
