Table of Contents
Advertisement
5.2 Network Viewer and Image
Viewer
This section provides instructions for installing and
using the Network Viewer and Image Viewer which
are included with the DVR. The programs can be
operated by a selected PC, which is equipped with
the following requirements.
1.
Intel Pentium 233MHz at least.
2.
32 MB RAM
3.
Windows 95, 98, NT, and ME.
4.
4 MB Video card capable of 24-bit true-color
display.
5.
5 MB free hard-disk space for software installation.
6.
10-base T network for LAN operation.
5.2.1 The Network Viewer
5.2.1.1 Introduction
The Network Viewer allows you to potentially
access 16 units of the DVR from a remote desktop
or a laptop in a TCP/IP networking environment. It
can perform the following functions.
View live images from the DVR.
Store, search, and review recorded video
from the DVR HDD.
Change the regular record, event record, and
timer properties.
Before you are ready to view images from a
desktop, you need to have your DVR networked by
obtaining a 10 base Ethernet cable (Standard
RJ-45) to connect the DVR to your LAN/WAN. Now
enter the main menu to set the IP address.
Physical specifications for Ethernet
Wire Type
Connector Type
Max. Cable Length
Hub Wiring Configuration
PC Wiring Configuration
Cat. 5
RJ-45
30 m
Straight Through
Cross Over
45
5.2.1.2 Installation
Install
the
Network
supported CD.
1. Exit all applications currently running on the
PC.
2. Insert the supported CD in the CD-ROM drive.
The program will execute the installation
automatically. Follow the on-screen instructions
to proceed with the rest of the installation
procedure as they appear.
3. After the installation is complete, pop up the
START menu from your computer, and point
to Programs / 1CH DVR Network Viewer to
open up the program selection page as
shown below. Click the 1CH DVR Network
Viewer tag to start the 1CH DVR Network
Viewer program.
Install the Network Viewer for the ZIP file.
1. Save the ZIP file to your PC and extract the
file to a designated directory, and open the
extracted folder.
2. Double click on the setup.exe to execute the
installation and then follow the on-screen
instructions to proceed with the rest of the
installation procedure as they appear.
3. After the installation is complete, pop up the
START menu from your computer, and point
to Programs / 1CH DVR Network Viewer to
start the 1CH DVR Network Viewer program.
NOTE:
Please
make
communication software has been properly
set and configured on your computer. To
check your TCP/IP settings, refer to the
following.
Viewer
from
the
sure
the
TCP/IP
Advertisement
Table of Contents
