Table of Contents
Advertisement
INSTALLATION
External Device
D. Attaching an
Connect an alarm out, alarm input, and a peripheral device as shown in the diagram below.
SD Card
FROM MUX
VIDEO
MAIN MONITOR
AUDIO
RS-485
IN
IN
ETHERNET
10/100
OUT
OUT
TO
TO
ALARM
MUX'S VCR IN
MONITOR
2.2 Hard-disk Drive Installation
The DVR is equipped with two compartments
of hard disk drive (for removable model
only), The unit usually comes with one
hard-disk drive installed in the compartment
HD1, which is default- configured as a master.
If you need a second hard-disk drive to be
installed in the compartment HD2 (Mobile),
please contact your distributors or installers
for specific instructions on how to install it.
Please don't serve yourself before consulting
your installers. If there is only one hard-disk
drive in the mobile compartment, please set
Table 3.2 A. The jumper settings of hard-disk drives in the system
IDE 1
IDE 2
to DVR
RS-232
I/O
DC12V
(Normally Open)
Ground
(Normally Open)
Location
Compartment HD 1
Compartment HD 2
( continued )
Lamp
Alarm Reset
5
4
3
2
1
9
8
7
6
Alarm in
the HD2 USAGE option to REC (please refer
to section 4.5) before proceeding with the
recording
function.
arrangement of installed hard-disk drives for
the system (Table 3.2 A.) is shown in the
tables below.
Note: The CD-RW model is equipped with a
fixed hard- disk and a CD-RW drive. The unit
usually comes with one hard-disk drive
installed in the compartment HD1, which is
default-configured as a master.
10
The
jumper-settings
Jumper
Master (Default)
Master
Advertisement
Table of Contents
