Recording Operations; Manual Recording; Timer Recording - IDVIEW IV-110TX-SN Installation & Operation Manual

3.2 Recording Operations

This section details the way to record video
into hard-disk drives. Before commencing with
the recording function, please configure the
recording setting properly according to your
needs.

3.2.1 Manual Recording

Take the following steps to start and stop
recording:
(1) Press the REC button
into a hard-disk drive with the corresponding
programmed recording settings. The REC
6
button will light up indicating the DVR is
in the recording status.
(2) Press the REC button
stop recording any time.
(3) To access just recorded video, please refer to
section 3.4 for more details.

3.2.2 Timer Recording

Timer recording provides
each day in a weekly table which programs
the DVR to turn on and off at specified times.
This way the DVR will start/ stop recording
according to the programmed schedule.
MAIN MENU
RECORD
ALARM / MOTION
CLOCK/ TIMER
COMMUNICATION
DISK
SYSTEM
GOTO CLOCK/ TIMER PAGE
REC SCHEDULE
START END START END
S
00:00- 00:00 00:00- 00:00
M
00:00- 00:00 00:00- 00:00
T
00:00- 00:00 00:00- 00:00
W
00:00- 00:00 00:00- 00:00
T
00:00- 00:00 00:00- 00:00
F
00:00- 00:00 00:00- 00:00
S
00:00- 00:00 00:00- 00:00
CANCEL
OK
TO MOVE
(1) Press the Setup button
MAIN MENU.
6
to record video
6
for 3 seconds to
2
periods of time
CLOCK/TIMER
CLOCK :SET
DAYLIGHT SAVING :OFF
REC ENABLE :OFF
TIMER :SET
TITLE :SET
MAIN PAGE
TO CHANGE
9
to enter the
(2) Select the CLOCK / TIMER and press the
Enter button
TIMER page.
(3) Select the TIMER－SET.
(4) Press the Enter button
SCHEDULE table.
(5) You can set up by using the "<" button
and the ">" button
day/hour/minute and use the "
and the "v"
day/hour/minute you wish.
You can also set up by using the Shuttle
Ring and the Jog Dial.
the "<" button
">" button 14
12
button and
button 13 .
The time is displayed in a 24-hour clock
format.
(6) After scheduling is completed, press the
Enter button
setting or select CANCEL to leave the page
without saving.
(7) To activate/ deactivate the programmed
recording schedule, set the REC ENABLE
to ON/ OFF. If the scheduled recording is on,
the red indicator of the Timer Record
will be on as well.
MAIN MENU
RECORD
ALARM / MOTION
CLOCK/ TIMER
COMMUNICATION
DISK
SYSTEM
GOTO CLOCK/ TIMER PAGE
CLOCK/TIMER
CLOCK
DAYLIGHT SAVING
REC ENABLE
TIMER
TITLE
MAIN PAGE
(8) Press the REC button
16
15 to enter the CLOCK /
15 to enter the REC
14 to locate the specific
^
" button
button 13 to set
is the equal of
11 , is the equal of the
, is the equal of the "
is the equal of the "v"
15 and set OK to save the
:SET
:OFF
:OFF
:SET
:SET
6
for 3 seconds
11
12
the
^
"
17