IDVIEW IV-110TX-SN Installation & Operation Manual page 43

COMM SETTING
: 01
COMM ID
: ON
RS232
: ON
RS485
NET ENABLE : ON
NET DHCP : ON
NET IP : SET
NET ACCOUNT
FTP SETTING
MAIN PAGE
You don't need to set a NET IP for the unit
if the LAN which the unit is connected to
DHCP server.
has a
follow the instructions given below:
Enter the NET IP page, and set the IP,
MASK and GATEWAY. Then press the
Enter button to proceed. The following is a
sample setting.
IP:
MASK:
GATEWAY:
HTTP PORT:
NOTE:
1. When only one unit of the DVR is
connected to a computer or LAN, you can
freely assign an IP address for the DVR. For
example, there is a range of DVR IP addresses
from 192.168.1.1 to 192.168.1.255. You can
pick one for use from the range of the IPs. It's
not necessary to set MASK and GATEWAY;
leave the settings as default.
When a DVR is connected to a WAN, you must
acquire a unique, permanent IP address and
correctly configure the MASK and GATEWAY
settings according to
architecture. If you have any questions
regarding those settings, please contact a
qualified MIS professional or your ISP.
2. Connecting to a network, each connected
Otherwise, please
192.168.1.100
255.255.255.0
0.0.0.0
80
your network
41
DVR must be assigned a unique IP, which
must be in the same class type as your
network address. IP addresses are written as
four sets of numbers separated by periods:
for example, 192.168.0.1 Therefore, if the
connected network is identified as Class C,
for example, the first three sets of numbers of
the DVR IP address must be the same as the
network address. If the connected network is
identified as Class B, the first two sets of
numbers of the DVR IP address must be the
same as the network address. If you have any
questions regarding these settings, please
contact a qualified MIS professional or your
ISP.